supplied.
repair. Safety lock mechanism shall not
interfere with the operation of the body
under any operating conditions.
4000
AUTOMATIC TRANSMISSION
3.5.4.7 DUMP BODY MOUNTING.
When code 4000 is specified, an
The body shall be located on the vehicle
Allison 4000RDS torque converter
chassis
in
accordance
with
type 5 speed overdrive automatic
manufacturer's
standard
commercial
transmission having a minimum
practice except that pivot point shall be
gross input capacity of no less
300 mm to 480 mm (12 to 18 inches) from
than the output of the supplied
the rear of the body. Full length rivet pads
engine shall be supplied. Power
or a full length subframe shall be attached
take-off provisions shall be
to the top of the chassis frame rails. The
supplied.
pads or frame rails shall prevent the body
longitudinal sills from contacting and
chafing against the chassis frame rails.
4500
AUTOMATIC TRANSMISSION
When code 4500 is specified, an
Allison 4500RDS torque converter
3.5.4.8 DUMP BED COVER.
type 5 speed overdrive automatic
A dump bed cover with front wind
transmission having a minimum
protector and operated from ground level
gross input capacity of no less
shall be provided. Dump bed cover shall
than the output of the supplied
be polypropylene, knit-mesh material with
engine shall be supplied. Power
70% (nominal) mesh content.
take-off provisions shall be
supplied.
3.6
OPTION CODES AND
REQUIREMENTS
A14
ALTERNATOR 145 AMP
When code A14 is specified, a
3000
AUTOMATIC TRANSMISSION
minimum 145-ampere alternator
When code 3000 is specified, an
shall be provided.
The
Allison 3000RDS torque converter
alternator output with the engine
type 5 speed overdrive automatic
at idle speed shall be not less
transmission having a minimum
than 70 amperes.
gross input capacity of no less
than the output of the supplied
AAS ASPHALT SPREADER FLOOR
engine shall be supplied. Power
EXTENSION.
take-off provisions shall be
When code AAS is specified, a minimum
supplied.
floor extension of 30 cm (12 in) shall be
provided. The floor extension shall be
constructed of 6.35 mm (.25 in) thick,
3500
AUTOMATIC TRANSMISSION
50,000 psi yield strength material.
When code 3500 is specified, an
Extension shall be full width of floor with
Allison 3500RDS torque converter
vertical end caps at each end that are
type 5 speed overdrive automatic
angled from rear edge of extension to
transmission having a minimum
body rear corner post. Extension shall be
gross input capacity of no less
supported underneath by a minimum of
than the output of the supplied
six (6) braces angled from extension to
engine shall be supplied. Power
body rear cross member/floor support.
take-off provisions shall be
Federal Standard 807M
Page 28 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business