only) and emergency reflective triangles
include: a 12-volt electrical power point
shall be provided. The stowage space
outlet (receptacle), easily accessible to
the seated driver; and tinted glass in all
shall provide for positive retention of this
windows, where optionally available from
equipment during vehicle operation.
the chassis manufacturer.
Stowage space for these tools may be
furnished in the cab. When stowage
3.4.12.1 CAB INTERIOR.
space for these tools is located outside
Unless otherwise specified, the cab shall
the cab, it shall be weatherproof and shall
have an upholstered, full width, adjustable
provide for locking with a padlock or
seat and back or individual, adjustable,
integral lock.
driver's seat and individual passenger
seat. The color of the upholstery and the
3.4.17
HEATER AND DEFROSTER.
interior finish shall be compatible with the
The vehicle shall be provided with a hot
exterior color. White upholstery shall not
water heater with fresh air intakes and
be furnished. Interior lighting shall be
discharge outlets to the floor and to
provided. Three sets of seat belts shall
windshield defroster louvers. The heater
be installed on bench seats. Outboard
shall be complete with blower and
seats shall have combination pelvic and
mounted controls convenient to the driver.
upper torso restraint seat belts. A rear
3.4.18
CONTROLS AND OPERATING
cab window shall be furnished, unless a
MECHANISMS.
sleeper compartment is specified.
All controls and operating mechanisms
shall be located for left hand drive.
3.4.13
STEERING.
Controls
shall
be
complete
and
Power steering shall be furnished.
conveniently operable by the driver.
3.4.14
WINDSHIELD
Lever controls shall be designed and
The vehicle shall be equipped with dual
located to permit easy entrance and exit
windshield
wipers
and
windshield
of the operator to and from the driver's
washers. Windshield wipers shall be of
compartment. Instruments and controls
the multi-speed intermittent type and
shall be identified as to their function and
operated by electric motor(s).
installed in a manner to facilitate removal
and servicing. All instruments shall be
3.4.15
BUMPER.
visible to the driver when seated in the
Unless the bumper is an integral part of
driving position.
vehicle cab, a channel type front bumper
shall be provided on each vehicle.
3.4.19
ACCESSORIES AND
EQUIPMENT.
3.4.15.1 REAR END PROTECTION.
Chassis equipment shall be complete with
Except for Type I chassis, Type II tractors,
all accessories furnished as standard
and Type IV dumps, the rear end of the
equipment by the manufacturer. The
vehicle shall be protected in accordance
following minimum equipment shall be
with Federal Motor Carried Safety
furnished:
Regulation 393.86. A rear bumper shall
(a) ... Key operated ignition switch
be provided as specified herein for the
(b) ... Ammeter or voltmeter
various vehicle types.
(c) ... Fuel gage
3.4.16
TOOL STOWAGE.
(d) ... Oil pressure gage
Stowage space of sufficient size to
accommodate a vehicle jack, hand tools,
(e) ... Engine coolant temperature
anti-skid chains (for outside tires on duals
gage
Federal Standard 807M
Page 21 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business