shall be installed using an anti-
The hydraulic system and
seize thread sealing compound.
hydraulically driven components
Teflon tape is not acceptable.
shall be operated and checked
for leaks and proper operation.
2.
Hoses shall be routed for easy
The operational test shall
tracing of hoses and shall be
include
the
maximum
protected with grommets when
requirements
(height,
passing through bulkheads.
extension, speed, etc.) of the
Hoses shall be protected from
driven devices under no-load
abrasion when routed over or
conditions.
No leakage is
through bare metal edges.
permitted beyond a class "1"
3.
Hydraulic hoses shall be
leak in accordance with SAE
supported with metal hose
J1176-External
Leakage
clamps that provide protection
Classifications for Hydraulic
for the hose from the metal
Systems.
portion of the clamp. Hoses
shall not be allowed to droop or
3.2
GENERAL DESIGN.
to be entangled with other
3.2.1
FEDERAL MOTOR VEHICLE
hoses or lines. The clamps
SAFETY STANDARDS.
shall be spaced not more than
The vehicle furnished accessories shall
18 in. apart.
comply with all Federal Motor Vehicle
4.
Overhanging weight of fittings,
Safety Standards in effect on the date of
hoses, valves, or piping shall be
manufacture.
supported from the reservoir to
eliminate flexing of sidewalls.
3.2.2
AIR POLLUTION CONTROL.
The vehicle shall comply with the
5.
All hoses shall be routed and
Environmental
Protection
Agency
installed in accordance with the
Regulations governing Control of Air
requirements
and
Pollution from New Motor Vehicles and
recommendations
of
SAE
New Motor Vehicle Engines in effect on
J1273.
Special attention to
the date of manufacture. Vehicles with a
routing and installation shall be
final destination of California or opt-in
given to avoid the following:
states shall comply with State of California
a. Tensile loads on the
regulations governing air pollution control
hose
in effect on the date of manufacture.
b. Side loads
3.2.3
SOUND LEVEL.
c. Flattening
The cab interior sound level shall not
d. Kinking
exceed 84 db(A) when measured in
e. Thread damage
accordance with Federal Motor Carrier
Safety Regulation 393.94. The vehicle
f. Damage
to
sealing
exterior sound level shall conform to the
surfaces
Environmental Protection Agency Noise
g. Abrasion
Emission Standards for Transportation
h. Twisting
Equipment, Medium and Heavy Trucks.
i. Exceeding
minimum
3.2.4
CURB WEIGHT.
hose bend radius
The curb weight is defined as the empty
j. Operational Test
weight (no payload included) of a fully
Federal Standard 807M
Page 12 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business