(f)..... High coolant temperature low
3.4.21
HORN.
coolant level and low oil
The manufacturer's standard electric horn
pressure alarm buzzer
shall be furnished, and in addition an air
operated horn shall be provided.
(g).... Speedometer with recording
odometer
3.4.22
BACK ALARM
(h).... Dual sun visors
A back-up alarm shall be provided which
(i) ..... Driver's compartment ventilator
provides an audible warning whenever the
other than window
ignition switch is "on" and the vehicle
transmission control is in reverse. The
(j) ..... Tachometer (for diesel engine
alarm shall automatically adjust to
driven vehicles)
ambient noise levels. Alarm shall conform
(k) .... Front door or seat mounted
to SAE J994.
armrest on driver and on
passenger side
3.4.23
AM/FM RADIO.
An OEM AM/FM radio with clock shall be
(l) ..... An engine shutdown system
provided.
shall be provided. The engine
shutdown system shall include
3.4.24
AIR CONDITIONING.
an engine coolant temperature,
The vehicle shall be equipped with the
engine coolant level and engine
chassis manufacturer's standard all
oil pressure red indicator
weather air conditioner. The use of a
warning light and alarm buzzer.
Class I or Class II controlled substance
The warning light and buzzer
refrigerant is prohibited. Air conditioning
actuation shall precede engine
system shall conform to TMC RP 418.
shutdown. The system shall
permit engine restart and run
3.5
VEHICLE TYPES.
for approximately 30 seconds
The cab-to-axle dimension specified for
following automatic shutdown.
the various vehicle types may be reduced
When a Gasoline engine is
by not more than 50 mm (two inches)
furnished, engine shutdown
when the vehicle is furnished with tilt type
feature is not required.
cab (see 3.4.12).
3.4.20
REARVIEW MIRRORS.
3.5.1
TYPE I (CHASSIS, WITH CAB).
Outside rearview mirrors shall be
Type I vehicles shall have one of the
mounted on both sides of the cab. The
usable cab-to-trunnion (CA) dimensions
mirrors shall have flat and convex areas.
shown in Figure 4 , as specified. Usable
The flat portion shall have not less than
cab-to-trunnion is defined as the distance
636 square centimeters (100 square
from
the
most
rearward
vehicle
inches) of reflective area. The convex
obstruction that would interfere with body
portion shall have not less than 324
mounting to the centerline of the trunnion
square centimeters (50 square inches) of
between the two rear axles. Load area for
reflective area. The convex portion shall
the purpose of determining weight
be attached to the lower mirror-supporting
distribution (see 3.2.6) shall be as
arm and shall not interfere with use of the
specified (see 6.2). Chassis shall be
flat mirror.
suitable for subsequent mounting of the
make, model and type of body and
equipment specified if specified (see 6.2).
Required CA dimensions must be
specified when vehicle order is submitted.
Federal Standard 807M
Page 22 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business