(g) Electronic
Control
Unit
and 8 inches deep) shall be
(ECU)
provided.
(h) Operator
Control
Panel
CPT
PAINT-CUSTOM COLOR
(OCP)
When code CPT is specified, a
custom or Federal Standard 595
(i)
Pneumatic
Control
Unit
color shall be provided.
(PCU)
(j)
Distribution Manifold (DM)
CSN
CAB, SHORT NOSE
CONVENTIONAL
(k) Wheel Valves
When code CSN is specified, a
(l)
Pressure Switch
conventional short length nose
cab with BBC of 94 to 101 inches
(m) Speed Sensor
shall be provided.
(n) Air Lines
(o) Wiring Harness
The system shall allow the driver
CTIS
CENTRAL TIRE INFLATION
to adjust vehicle tires to any of
SYSTEM
four pre-set tire pressures
When code CTIS is specified, a
(highway and off-highway for
central tire inflation system shall
both loaded and unloaded
be provided. The system shall
conditions) on up to three
include but not be limited to the
separate
channels
following components:
(steer/drive/trailer) and shall
(a) 850 L/min (30 CFM) air
include an emergency key and a
compressor with 14 liter
run flat key.
System shall
engines and above; 453
provide
for
manual
tire
L/min (16 CFM) with
inflation/deflation capability, an
engines between 10 liters
air
priority
system,
and
and 14 liters; and 373
speed/pressure control, and
L/min (13.2 CFM) with
warning at OCP.
engines less than 10 liters
D1
DIFFERENTIAL LOCK OUT
(b) Compressor with automatic
When code D1 is specified, a
moisture ejector
driver
controlled
differential
(c) Axles
compatible
with
lockout shall be provided.
installation of the Central
Tire Inflation System
D3
SPECIAL TRACTION
DIFFERENTIAL
(d) 10 hole disc type wheels,
When code D3 is specified, the
all axles
differential traction control shall
(e) Front axle-standard profile
actuate automatically to ensure
tires with highway type
that power is transmitted to the
tread
(low
profile
wheel having traction when the
acceptable
on
opposite wheel loses traction.
18000/20000 lb axles)
DA
DELETE AIR CONDITIONING
(f)
Rear axle-standard profile
When code DA is specified, the
tires with traction type tread
vehicle supplier shall furnish the
Federal Standard 807M
Page 34 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business