plate/gravel guard shall be
0 degrees. The actual length of the
secured to the front bumper and
moldboard shall be not less than
shall be not less than 6.4 mm
3050 mm (10 feet). The moldboard
(0.25 inch) or greater than 9.5
of
the
one-way
snowplow,
mm (0.375 inch) from the
exclusive of the snow deflector,
chassis sheet metal. The step
shall have a vertical height of not
plate/gravel guard shall be
less than 780 mm (30 inches) on
fabricated of not less than 14
the left side (street-side), 1370 mm
gage (1.897 mm) (0.0747 inch)
(54 inches) on the right side
steel tread plate exclusive of
(curbside). The one-way snowplow
projections.
The
step
shall have a minimum of two angle
plate/gravel guard shall be
adjustments. The plow shall be
capable of supporting 1460
shipped in the load space and
kg/m2 (300 pounds per square
lights shall be shipped within the
foot).
The step plate/gravel
cab when possible. Brackets and
guard shall be supported so that
connections shall be installed on all
it will not deflect more than 3.2
vehicles
to
enable
ready
mm (0.125 inch) under the
installation for the lights and
required load.
snowplow at the destination.
Snowplow and lights shall be
MIL
DATA PLATES AND DD250
installed on the first vehicle to
When code MIL is specified, the
assure proper operation, and they
following
shall
be
supplied.
may be removed for shipment after
1. A Nameplate as described in
Government inspection.
When
paragraph 5.6.1 of MIL-HDBK-
code MPN is specified, a chassis
1223 "NONTACTICAL WHEELED
hood that will permit checking of
VEHICLES
TREATMENT,
normal maintenance items such as
PAINTING,
IDENTIFICATION
oil and water with the snow plow
MARKING AND DATA PLATE
attached shall be supplied. The
STANDARDS".
The
front GAWR shall be not less than
nameplate/data plate shall be
the load imposed by the furnished
completed in accordance with
snowplow, in raised position, plus
requirements of receiving military
the front axle portion of the
service and attached to the
required payload for the Federal
vehicle(s).
No other exterior
Standard Item No. plus the actual
military
markings
shall
be
front axle curb weight for the
furnished.
vehicle. The rear GAWR shall be
2.
DD Form 250 "MATERIAL
not less than the load imposed by
INSPECTION AND RECEIVING
the required payload for the Item
REPORT" furnished in lieu of a
No. without the snowplow plus the
GSA form 308.
chassis and body rear axle weight.
Note: when code MPN is specified,
a significant increase could be
MPN
SNOWPLOW, ONE-WAY
required in the chassis GVWR
When code MPN is specified, the
when a snowplow is installed. The
plow shall be of the one-way type
increased GVWR could change a
with a cut of not less than 2440 mm
non-FET chassis to a chassis that
(96 inches) with a blade angle of
requires FET.
35 degrees plus 2 degrees, minus
Federal Standard 807M
Page 43 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business