MTR
MARINE TRANSPORTABILITY
lights shall be provided for use with
When code MTR is specified,
the snowplow. Parking and turn
marine
transportability
signal lights shall use a single light
requirements for class C, D, E
bulb. Mounts, adapters and an
and F vehicles shall include
appropriate wiring harness shall be
unrestricted water transport by
provided. Quick disconnect plugs
all
standard
military
and
and receptacles shall be provided
commercial
watercraft
in
and shall be weatherproof, or shall
accordance with the interface
be located in a weatherproof
criteria published in "MIL-STD-
location. A high beam indicator
1366 Transportability Criteria".
light shall be provided and shall be
In addition, all vehicles must be
readily visible to the driver when in
equipped with military standard
the driving position.
lifting and tie down provisions
Snowplow markers shall be
(option LTD) as specified in MIL-
provided for the street side and
STD-209 and option code LTD
curbside of the snowplow. The
(section 3.1.1.21.5) also see
markers shall be removable when
3.1.1.21. See 4.4
not in use. The markers shall
eliminate guesswork as to position
NAS
SPREADER TAILGATE
of the snowplow caused by blind
When code NAS is specified, an
spots.
under-tailgate type sand and salt
spreader shall be provided and
shall be easily removable.
When only code NAS is
MS
MUD & SNOW TIRE
specified, the sand and salt
When code MS is specified on
material
feed
auger
and
6x4 vehicles, mud and snow
spreader shall be hydraulically
tread shall be provided on rear
powered by a PTO mounted
axles.
hydraulic pump or by its own
auxiliary engine driven hydraulic
MTL
TRAILER LIGHTING CABLE 110
pump. Controls shall be located
INCHES
in the cab. Hydraulic lines shall
When code MTL is specified, a
be
provided
with
quick
trailer lighting cable conforming
disconnect hose couplers. Hose
to SAE J1067 shall be provided.
caps, pump caps and hydraulic
The cable shall be coiled and
motor caps shall be provided if
shall be not less than 2800 mm
no other protection system is
(110 in) long when fully
provided.
Caps shall be
extended. Both ends of the
secured with a corrosion-
cable shall be equipped with a
resistant security device to
round plug conforming to SAE
prevent loss. Caps shall prevent
J560.
The plugs shall be
entrance of contaminants into
equipped with a grip for
the hydraulic system when
withdrawing from the connector
disconnected.
sockets. The cable shall be
packaged and stowed in the
NSP
SAND AND SALT SPREADER
vehicle tool compartment.
When code NSP is specified, a
skid mounted sand and salt
Federal Standard 807M
Page 46 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business