attachments.
Tie
down
markings shall clearly indicate
TP
TWO TONE PAINT
that
the
attachments
are
When code TP is specified, any
intended for the tie down of the
of the manufacturer's production
equipment on the carrier (also
multi-tone paint combinations
see 3.1.1.21). See 4.4.
may be selected.
TJ
TOOLS-TIRE REMOVAL AND
TS
TILT STEERING
JACK
When code TS is specified, the
When code TJ is specified, tools
vehicle shall be equipped with
for changing a mounted tire
the chassis OEM tilt steering
assembly
with
the
spare
column.
assembly shall be provided.
Tools shall include at least a
TSTF
SYNTHETIC AUTOMATIC
hydraulic jack, jack handle and
TRANSMISSION FLUID
wheel nut wrench. The jack
When code TSTF is specified,
shall be of such closed height as
the automatic transmission shall
to permit its location under an
be furnished with synthetic
axle, or other satisfactory lift
lubricant.
Lubricant supplied
point at any wheel with the tire
shall be approved by the
flat. The jack, without blocking,
component manufacturer and
shall be capable of raising any
furnished by the chassis OEM.
wheel of the loaded vehicle to a
height adequate to permit
TSW
RATCHET BINDERS
removal and replacement of a
When code TSW is specified,
wheel and tire assembly.
load securing straps and winch
binders shall be provided. Code
TMA
FULLY AUTOMATED
TSW shall include the following:
MECHANICAL TRANSMISSION
a) 4 inch wide by 27 feet long
When code TMA is specified, the
(minimum) nylon straps
vehicle shall be furnished with a
webbing, breaking strength
shift by wire, fully automated
20000
lb/9074
kg,
mechanical
transmission
(two
assembled
breaking
pedal vehicle operations).
The
strength 15000 lb/6805 kg.,
transmission
shall
utilize
a
working load limit 5000
mechanical clutch and provide a
lb/2270 kg.
Flat hook
power takeoff opening. The input
working load limit 5000
torque capacity of the transmission
lb/2270 kg on one end with
shall be at least equal to the
aluminum abrasion clip to
maximum torque delivered by the
prevent chaffing.
engine. Transmission shall utilize
SAE J-1939 protocol and be
b)
Sliding steel track on
compatible for interface with
curbside, welded to bottom
electronic engine.
of crossmembers from first
crossmember
to
last
crossmember,
with
removable stop at each
end to prevent winches
from being lost. Flat steel
Federal Standard 807M
Page 53 of 65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business