MIL-DTL-62034G(AT)
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI/ASQC Z1.4
-
Sampling Procedures and Tables for Inspection by
Attributes (DoD Adopted)
(Copies of these documents are available from American National Standards Institute, 25 West
43rd Street, New York, NY 10036 or website: https://www.ansi.org/)
SAE INTERNATIONAL
SAE J682
-
Wheel, Rear, Splash and Stone Throw Protection (DoD
Adopted)
SAE J2014
-
Pneumatic Tires for Military Tactical Wheeled Vehicles
(DoD Adopted)
(Copies of these documents are available from www.sae.org or SAE Customer Service, 400
Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event
of a conflict between the text of this document and the references cited herein, the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article
inspection in accordance with 4.2.
3.2 Materials. Materials used shall be in accordance with the manufacturer s materials
specifications for semitrailers. The materials shall be capable of meeting all of the operational
and environmental requirements specified herein (see 4.5.1). Recovered materials shall be used
to the maximum extent practicable.
3.3 Construction. Semitrailer shall be constructed in accordance with the applicable
drawing specified in table I, specifications and standards, and as supplemented herein (see 4.5.2).
If more than one unit of a particular component is used in or on the semitrailer, the components
used shall be identical in make, material, and quantity. The riveting, welding practices, and
quality shall be the same on each semitrailer (see 4.5.2).
3.3.1 Seals. When fording or operating in mud, sand, or snow, seals shall prevent
entrance of foreign matter into the bearings, which are exposed to contamination during these
operations. All bearing seals shall restrict the leaking of lubricants from bearings (see 4.5.2).
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business