MIL-DTL-62034G(AT)
4.5 Methods of inspection.
4.5.1 Materials. Conformance to 3.2 shall be determined by inspection of contractor
records providing proof or certification that materials conform to requirements. Applicable
records shall include drawings, specifications, design data, receiving inspection records,
processing and quality control standards, vendor catalogs and certifications, industry standards,
test reports, and rating data.
4.5.2 Defects. Conformance to 3.3, 3.4.3, 3.4.7, 3.4.10.2.1, and 3.5 through 3.10 shall be
determined by examination for the defects listed in table IV. Examination shall be visual, tactile,
or by measurement with SIE.
4.5.3 Environmental test. To determine conformance to 3.4.1, the semitrailer, properly
serviced and equipped shall be exposed for 24 hours to each of the extreme temperature
conditions shown in the requirement and then subjected to the applicable tests.
4.5.4 Highway and cross-country test. To determine conformance to 3.4.2.1 and 3.4.2.2,
the semitrailer will be loaded with the applicable payload specified in table III over the specified
terrain at specified speeds and observed for satisfactory operation performance.
4.5.5 Service brake test. To determine conformance to 3.4.3.1, the semitrailer towing
vehicle combination shall be operated as specified and observed for stopping at the specified
distance.
4.5.6 Automatic actuation device test. To determine conformance to 3.4.3.2, the
automatic actuation device shall be actuated, to assure that brake application is maintained and
semitrailer holds stationary for the specified period on a specified grade.
4.5.7 Fording test. To determine conformance to 3.4.4, the semitrailer shall be operated
in water at specified depth and time period. Upon completion of fording operation, all sealed
items and wheel bearings shall be examined. Entrance of water that would preclude proper
function of the brake system or wheel bearing shall be cause for rejection.
4.5.8 Tracking ability test. To determine conformance to 3.4.5, the semitrailer with
prime mover shall be operated as specified and observed for deviation from the path of the prime
mover.
4.5.9 Turning ability test. To determine conformance to 3.4.6, the semitrailer
combination shall be operated as specified and observed for specified turning angle in both
directions and observed for interference with prime mover.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business