MIL-DTL-46714E(AT)
b. The "US" stencil marking shall not be applied.
c. All marking callouts, interior and exterior (for example, "Use for Lift Only," "Tire
Pressure," etc.) shall be painted black. The dividing line between markings and the
van's regular exterior paint shall be sharp and clear.
3.6.1 Identification data plates. The actual weight of the first five vehicles, with all
miscellaneous equipment in proper stowage position, shall be hand stamped on subject vehicle
identification plates. The actual weights shall be rounded-up to the nearest 50 lbs. The remaining
vehicle identification plates shall have the weight of the first production vehicle printed on the
data plates (see 4.5.2).
3.7 Servicing and adjusting. Prior to acceptance of the semitrailer by the Government,
the contractor shall adjust and service each semitrailer for operational use including, as a
minimum, the following: Fill and adjust the brake system, check the electrical system, check the
tire pressure, and completely lubricate the semitrailer with specified lubricants for the ambient
temperatures at the delivery point (see 4.5.2).
3.7.1 Lubrication. The contractor shall lubricate the semitrailer componentry in
accordance with the applicable drawing(s) and as follows:
a. All exposed surfaces of the fully extended lower leg on each landing gear
assembly.
b. All surfaces of each lifting eye and all surfaces of each lifting eye housing.
c. The threads of each aircraft tiedown provision.
d. The entire exposed surface of the kingpin.
e. The kingpin bolster plate surface.
f. All exposed surfaces of the door hinge pins (prior to assembly), door lock keepers,
door handle o-ring (prior to assembly), striker plates, van rubber gaskets, and
door-lock pivot points.
g. All threads of the leveling jack screw and housing assembly.
h. Each landing gear handle (prior to assembly).
3.8 Workmanship. Workmanship shall be of such quality as to assure that the semitrailer
and its components are free from-defects that compromise, limit, or reduce the capability of the
semitrailer in the performance of its intended use. The semitrailer shall exhibit good workmanship
throughout, evidencing good quality manufacturing practices. Examples of good workmanship
include, in part (see 4.5.2):
a. Straight rivet lines and uniform spacing of rivets.
b. Caulking and sealant surfaces smooth and uniform.
c. Paint surfaces in accordance with 3.5.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business