MIL-DTL-62073H(AT)
3.8.2 Fording. The trailer shall be capable of being towed in fresh or salt water of any
depth great enough to immerse the chassis entirely for periods up to 15 minutes without
impairing performance of the trailer or its components. Fording shall be accomplished without
use of special kits and with a minimum of preparation or servicing before and after the fording
operation (see 4.9.1).
3.9 Human factors. The trailer shall be operable and maintainable by a fifth percentile
female through a ninety-fifth percent male wearing arctic and/or MOPP IV clothing. All hand
holds and steps necessary for Army personnel to gain access to locations on the trailer platform
shall be an integral and permanent part of the trailer. The trailer design should utilize
MIL-STD-1472, and recommended practice MIL-HDBK-759 as reference. The spare wheel
and tire assembly shall be removable and stow-able by two operators. All functional items of
the trailer and all modes of operations shall be operational in/under arctic conditions (at minus 30
degrees F with moderate winds) with personnel in arctic clothing. All functional items of the
trailer shall be operational in a safe manner under poor outside conditions. All human
engineering requirements are applicable except for the maintenance function involving changing
a flat tire, removal and installation of bulkheads, and tarps (see 4.9.2).
3.10 Service parts. The trailer shall have Government parts support and a Department
of Army (DA) technical manual (see 4.9.3).
3.11 Workmanship. Material shall be free of defects and imperfections that might
affect the serviceability and reliability of the finished product (see 4.9.4).
3.12 Rear end protection. The rear end protection of the M1061A1 trailer shall
comply with the requirements of 49CFR393.86, 49CFR571.223 and 49CFR571.224
4.
VERIFICATION
4.1 Classification of inspections.
The inspection requirements specified herein are
classified as follows:
a.
First article inspection (see 4.2).
b.
Quality Conformance inspections (see 4.3).
c.
Control Tests (see 4.4).
d.
Comparison tests (see 4.5)
4.2 First article inspection. When first article is required (see 3.1), first article
inspection shall be performed on first article samples and shall include the inspections specified
in table IV (see 6.2). Road testing shall be required prior to conducting the tests specified in
table IV.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business