MIL-DTL-62164E(AT)
3.7 Marking. The required tire pressures shall be stenciled in white enamel in two
control locations with letters and figures legible at a distance of 20 ft. Lift points (see 3.4) shall
be identified with stenciled letters using white enamel legible at a distance of 20 ft. The trailer
shall be marked with the National Stock Number (NSN) and the manufacturer's name and part
number. Markings shall be permanent and legible. All parts, subassemblies shall be identified
when specified on drawings (see 4.5.2).
3.7.1 Identification and data plates. Identification and data plates shall be permanent and
shall be made of a material suitable to withstand the environmental requirements specified herein
and remain legible (see 4.5.2).
3.8 Servicing and adjustment. Prior to delivery, the contractor shall service and adjust
each vehicle and its mounted material for operational use including the following: Adjustment
of brake system, inflation of all tires, complete lubrication of chassis, suspensions and axles with
proper grade of lubricant (per approved lubrication chart) for the climatic condition at the
delivery point (see 4.5.2).
3.9 Manpower and personnel integration (MANPRINT). The vehicle shall comply with
the safety requirements of 4.5.4. The characteristics of the vehicle shall provide for operation by
personnel in all types of clothing and shall be designed in accordance with ISO 3411 (see 4.5.2).
3.10 Workmanship. All parts, components and assemblies of the truck including
castings, forgings, molded parts, stamping, bearings, seals, machined surfaces and welds shall be
clean and free from sand, dirt, fins, pits, cracks, sprues, scales, flux and other harmful extraneous
materials and defects. External surfaces shall be free from burrs, sharp edges and corners except
when sharp edges and corners are required. Electric wires and air lines shall be located in a
manner so as to prevent possible damage by rubbing on adjacent lines or appendages (see 4.5.2).
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2).
b. Conformance inspections (see 4.3).
4.2 First article inspection. Unless otherwise specified (see 6.2), first article inspection shall
be performed on preproduction or initial production samples as specified when a first article sample is
required (see 3.1). This inspection shall include the examinations of 4.4 (see table II) and the tests of
4.5.3 through 4.5.4 (see table III).
4.2.1 Preproduction inspection. When specified (see 6.2), first article preproduction
inspection shall be performed on two trailers. This inspection shall include the examinations of
4.4 (see table II) and the tests of 4.5.3 through 4.5.4 (see table III).
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business