MIL-S-62294B(AT)
vehicle, by tracks, track pads and wheels, and any other non-evenly distributed loads indicated by the full range of intended uses specified in 6.1.
3.4.2 Weight distribution. Load bearing members shall be rated for the loads imposed with the frame in a horizontal position, and the payload evenly distributed over the load space. The proportion of the gross weight of the loaded semitrailer to be supported on the axles and suspension system, measured at the ground, shall be approximately equal to, but not more than,
34,000 pounds.
3.5 Dimensions and clearances. The semitrailer shall be a two-level type having a lower main deck and a full width kickup (gooseneck) deck. The semitrailer shall conform to the dimensions specified in table II while resting on the landing legs on level ground, uncoupled from the towing vehicle, without payload. The term "lower deck" (see table II) is defined as the lower main deck and the hydraulic ramp.
TABLE II. Dimensions and clearances.
*
*
*
* 3.6 Construction and stresses. Main frame members shall be adequately braced with a sufficient number of crossmembers to present a rigid construction with sufficient strength for the loads imposed. The outside frame members shall run the full length of the loadspace. The rear crossmembers shall extend the full width of the semitrailer. When the semitrailer is loaded with rated payload, and with the loads distributed as specified in 3.4.2, the maximum fiber stress in
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business